ARGENTO Performance Pro Bedienungsanleitung Seite 24

DANGER
It is strictly prohibited to enable the walk assist mode when you are sitting on the saddle of the electrically power assisted
cycle to avoid the danger of injury and the risk of damaging the electrical components of the bike.
Switching the light on/off
Press the – button for 3 seconds to switch the front light on and off.
Viewing data (ODO - TRIP)
Available distance data will be displayed alternately and automatically in the following sequence: ODO (total distance data
display) - TRIP (partial distance data display).
Partial distance data (TRIP) can be reset by simultaneously pressing the + and - buttons for a duration of 2 seconds.
Indicator light for residual battery charge
The battery charge level is shown on the display screen as a number of dashes between 0 and 5.
If there are 5 dashes, it means that the battery is charged to the maximum percentage defined and detected instantly.
Less dashes are shown to indicate a decrease in the battery charge level available and subsequent autonomy.
The level of the battery charging indicator may fluctuate depending on how the electrically power assisted cycle is being
used, for example, when going up a slope, the level displayed can drop rapidly as there is a much higher battery consumption.
The individual dashes indicate the specific battery charge range detected at the time and do not necessarily indicated a
percentage of the residual autonomy.
Malfunction indicator light
If a malfunction of the product's electrical and/or electronic system is detected, a ! warning light appears on the display screen
and the corresponding Error Code is simultaneously displayed.
Refer to the following summary table to find the description of the fault and the corresponding action to be taken to allow
the product to be restored to correct operation, either by you alone and/or by contacting the after-sales service to receive
appropriate help: www.argentoemobility.com/en/support/
Error code Malfunction description
0001 Communication problem with battery. Battery status
data may be displayed incorrectly.
0101 Communication problem between Motor (Drive Unit)
and Display.
0104 Speed sensor not detected.
0105 Non-compliant torque sensor signal.
The torque sensor signal has a fault.
Operation at reduced power.
0106 Non-compliant torque sensor offset.
The torque sensor signal has a fault.
0801 Motor rotation sensor fault.
0802 Pedal rotation sensor fault.
Resolution / Suggested action
Check that wiring and battery contacts are
correctly connected and undamaged.
Check that wiring is correctly connected and
undamaged.
Check that the speed sensor is installed and
connected correctly.
Check that the magnet and the speed sensor
are correctly aligned (speed sensor magnet
positioned on the rear wheel spoke in front of
the letter 'O' in the 'OLIeds' on the sensor; Fig.A).
Contact authorised technical support service.
Contact authorised technical support service.
Contact authorised technical support service.
Contact authorised technical support service.
23