Herunterladen Inhalt Inhalt Diese Seite drucken

Anbau An Den Schlepper - Sip Roto 281F Betriebsanleitung Und Ersatzteilliste

Front trommel mäher
Inhaltsverzeichnis
ANBAU
AN DEN SCHLEPPER
1. Den
Mähen
schliessen
Schlepper
mit
Hilfe
Anschluss
der
II. Kat. an. Sie schliessen
dem Anschluss an die vorne Stange des
Schleppers
an und lassen Sie ihn in die
niedrigste Position. Dan nähern Sie sich
mit
Anschluss
bis
Mäheranschlusses (Bild 7) mit Hilfe von
der Hydraulik
heben Sie ihn in die Stelle
der Profildreieck
auf dem Mäher bis sich
der Sicherheitshaken verschnappt.
2. Durch das Sicherheitshaken R Siecherung
einsetzen. R Siecherung verhindett den
Sicherheitshaken vom herausspringen und
damit aufhakung des Mähers bewirken.
0b
sich
das
Sicherheitshaken
eingerückgt,
müssen
Hakenanschlag Pos. 10 (Bild 4) einstellen.
Das machen Sie so, das Sie den Schraub
Pos.
B
(Bild
4)
Hakenanschlag anpassen.
3. Der Mäher regulieren
Parallel von Boden Oder ein bischen nach
vom geneight ist. Das regulieren Sie mit
der Schiene Pos. B (Bild 8) bei das vorne
hydraulisches Gestänge.
Der Mäher soil nicht nach hinten geneigt
sein.
Bild
7
Fig. 7
Sie
an
dem
von
automatischen
das
Fussgestell
nicht
Sie
den
lösen
und
den
Sie so, dass er
CONNECTION
TO THE TRACTOR
1.
The mower
should
be mounted
tractor
by
automatic
category,
which should be connected
the front hydraulic bars of the tractor, and
lowered to the lowest position. Get close
to the frame
of the mower
automatic hitch (fig. 7), than start lifting it
by hydraulics towards the place where the
profile triangle
is positioned,
safety hook reaches its proper position.
Insert the R shaped wire safety clamp,
2.
which
prevents
the safety
slipping
out
and
from
disconnection
of
the
tractor, into the safety hook. In case the
safety hook does not get into its position,
the hook holder (pos. 10 — Fig. 4) must
be adjusted. This can be done by
unscrewing the screw pos. B (Fig. 4) and
adjusting the hook holder.
3.
Set the mower parallel with the ground or
slightly leaned forward. This can be done
by The support pos. B (fig. 8), which is
placed near by the front hydraulic bars. In
no case
should
the
backwards.
Bild
Fig. 8
to the
hitch
of
the
II.
to
hitch with the
until the
hook from
causing
the
mower
from
the
mower
be
leaned
8
37
Inhaltsverzeichnis
loading

Inhaltsverzeichnis