Shark MATRIX PLUS RV2620WAEU Gebrauchsanweisung Seite 11

MAINTENANCE
CLEANING THE VAC & MOP 2-IN-1 DUST BIN AND MOPPING PAD
To clean pads, machine wash warm with light
colors. Use mild detergents and do not use bleach
or fabric softeners. Air-dry, or tumble-dry on low
with no dryer sheets.
NOTE: Before storing, make sure the Vac & Mop 2-in-1 Dust Bin and pad are completely dry. Store them in a dry place to
prevent damage.
Empty the remaining liquid and the debris from the
fluid reservoir after each use. Using a damp cloth,
wipe the inside of the dust bin. Let the dust bin air
dry for 24 hours before use. DO NOT put Vac & Mop
2-in-1 Dust Bin in the dishwasher.
MAINTENANCE
CLEANING THE SELF-CLEANING BRUSHROLL
The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair
wrap or debris remains after continued cleaning, carefully remove it from the brushroll.
To access the brushroll, push up on the tabs on the
brushroll door, then lift off the door.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkclean.eu for replacement parts.
CLEANING THE LIDAR NAVIGATION MODULE
Lift out the brushroll and remove any debris.
Remove the end cap to clean out any trapped hair
or debris. Replace the end cap once clean.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll door and press down until both
sides click into place.
Periodically check the LIDAR navigation module
on top of the robot for hair and debris. Gently wipe
away any hair or debris from the module.
For a more thorough cleaning, place the robot on
a level surface and turn off the power. Use a cotton
swab to gently rotate the module clockwise five
times.
Do not insert cotton swab inside the openings in the
module.