Herunterladen Diese Seite drucken

Shark MATRIX PLUS RV2620WAEU Gebrauchsanweisung Seite 10

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 30
MAINTENANCE
CLEANING AND REPLACING THE SELF-EMPTY BASE FILTERS
Regularly clean the filters to keep your vacuum's suction power optimal. Replace filters every 6-12
months or as needed.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
trash, then rinse with cold water ONLY, as soap may
damage them. Allow filters to air-dry completely before
reinstalling them. The filters must be installed correctly
for the base to work properly. Reinsert the felt filter
first, then the foam filter.
Filter
Door
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door and
slide the latch down to lift Filter Door off. Remove
the Post-Motor Filter from the base. Tap the filter
clean over the trash. You may wash with water only
and be sure to fully dry before re-inserting it into the
base. To reinstall the post-motor filter, insert it into
the base and replace the filter door.
MAINTENANCE
CLEANING AND REPLACING THE ROBOT'S FILTERS
For optimal suction power, please clean and reinsert the Self-Empty Dust Bin filter after each use.
See sharkclean.eu for replacement parts and accessories.
Remove and empty the Self-Empty Dust Bin. Pull
filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
Lightly tap the filter to remove debris every time
you empty the dust bin. Replace the filter every
6-12 months or as needed.

Werbung

loading