HMS LOOP10 Bedienungsanleitung Seite 26

Operation Instructions
One、. Operation and Running
1. Remote Control Introduction
The remote control has three buttons: the upper button is "+", the lower button is "-",
and the middle button is "Start/Stop".
1.1 "+": Increases speed during operation.
1.2 "-": Decreases speed during operation.
1.3 "Start/Stop": In standby mode, press "Start/Stop" to start the machine; during
operation, press "Start/Stop" to pause the machine, the window displays "PAUS", and
the exercise data is retained. Press "Start/Stop" again, and the machine will run at 0.8
KM/H; during operation or pause, hold the "Start/Stop" button for 3 seconds to stop the
machine and reset the data.
2. Remote Control Pairing
Hold the "+" button on the remote control and power on until the buzzer beeps once,
indicating successful pairing.
3. Metric/Imperial Switching
Hold the "Start/Stop" button and power on until the window displays "SI". Press "+" or
"-" to switch between metric and imperial units. "Eng" indicates imperial units, and "SI"
indicates metric units.
4. Starting the Treadmill