Parkside Performance PABSP 20 Li C4 Originalbetriebsanleitung Seite 42

˜ Charging the battery pack
(Fig. C)
NOTE
The battery pack
u
at any time without reducing its life.
Interrupting the charging process
u
does not damage the battery
pack .
[ ]
Charge the battery pack
o
operation when it is at medium or low
charging level.
The charging control LEDs (green
o
and red ) indicate the status of the
[ ]
charger and the battery pack
[ ]
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack) Charger ready
1. Insert the battery pack
charger .
[ ]
2. Connect the power cord with
power plug of the charger
[ ]
the socket.
3. When the battery pack
charged: Remove the battery pack
from the charger
the power plug
[
the socket.
40 GB/IE
may be charged
[ ]
before
[ ]
[
:
[ ]
Status
Battery pack
charges
Battery pack fully
charged
Battery pack
defective
Battery pack too
cold or too warm
into the
[ ]
to
[ ]
is fully
[ ]
. Then disconnect
[ ]
of the charger from
]
˜ Attaching/removing the
accessory tool
CAUTION! Risk of injury!
m
Accessory tools can be sharp
and may become hot during use.
Always wear protective gloves
when handling accessory tools!
WARNING!
m
Always switch the product off,
remove the battery pack
let the product cool down before
making any adjustments!
]
CAUTION! Risk of injury!
m
Keep your hands away from the
u
accessory tool when the product is
in operation.
After the product has been switched
u
off, the accessory tool continues
moving for some time. Do not touch
the accessory tool and do not
attempt to brake it.
This product is equipped with an
automatic spindle lock to open or close
the chuck with the chuck ring
[ 1 ]
1. Open the chuck
ring in a counter-clockwise
[ 2 ]
direction (Fig. E).
2. Insert a suitable accessory tool into the
chuck as deep as required.
1 ] [
3. Close the chuck
accessory tool in position. Turn the
chuck ring
[
2 ] [
: Turn the chuck
1 ] [
: Hold the
1 ] [
in a clockwise direction.
2 ] [
and
]
.