Haier H4MWID49G6NQB Bedienungsanleitung Seite 7

installation instructions.
• Do not install or operate the appliance if it is damaged or not
working properly. If you receive a damaged product, contact your
dealer or installer immediately.
• The appliance must not be installed behind a decorative door in
order to avoid overheating.
• Do not mount this appliance over a sink.
• This oven is not approved or tested for marine use.
• Do not store this appliance outdoors. Do not use this near a
swimming pool, near a sink or in similar locations.
• Do not immerse cord or plug in water. Do not let cord hang over
edge of table or counter. Keep cord away from heated surfaces.
• The electrical installation of the oven should be equipped with an
emergency switch, which switches off the whole appliance from the
mains supply in an emergency. The distance between the contacts
of the emergency switch must be at least 3mm.
• Do not cover or block any openings on the appliance.
• Take care – some edges are sharp.
Electrical warnings
• IF THE MICROWAVE OVEN IS PROVIDED BY THE MANUFACTURER
WITHOUT PLUG: THE APPLIANCE MUST NOT BE CONNECTED TO THE
POWER SOURCE USING PLUG OR SOCKETS, BUT MUST BE DIRECTLY
CONNECTED TO THE SUPPLY MAINS. The connection to the power
source must be carried out by a suitably qualified professional.
In order to have an installation compliant to the current safety
legislation the oven must be connected only placing an omnipolar
breaker, with contact separation compliant to the requirements
for overvoltage category III, between the appliance and the power
source. The omnipolar breaker must bear the maximum connected
load and must be in line with current legislation. The yellow-green
earth cable should not be interrupted by the breaker. The omnipolar
breaker used for the connection must be easily accessible when
the appliance is installed. The connection to the power source
must be carried out by a suitably qualified professional considering
EN 7