Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DM600MAX
specification section of Frequency.
Measuring Voltage in LoZ Mode
CAUTION
• Do not use the LoZ mode to measure voltages in circuits that could be damaged by
this mode's low impedance.
To eliminate ghost voltages, the meter's LoZ mode presents a low impedance across
the leads to obtain a more accurate measurement. In this mode, meter will automatic
measure input signal which is AC or DC and determine range.
To use the LoZ mode, turn the rotary switch to LoZ position
Measuring AC and DC Current
WARNING
• Always use proper terminals, switch position, and range for measurements.
• To avoid possible electric shock or personal injury, never attempt an in-circuit current
measurement where the open circuit potential to earth is greater than 1000V.
• Only replace the blown fuse with the proper rating as specified in this manual.
CAUTION
• Replace the fuse as soon as the indicator (FUSE) appears.
To measure current, you must break the circuit under test, then place the meter in
series with the circuit.
12
EN
Werbung
