Power Probe DM600MAX Benutzerhandbuch Seite 11

DM600MAX EN
• Memory
Memory Options
Function DATA Location Capacity
SAVE
MEM Record 100
Auto-Saving
LOG LOG Record 40000
• SAVE/Auto-Saving
SAVE function can let you store the current primary reading into the meter. Press SAVE
to store the reading.
You can also operate the Auto-Saving mode to automatically save new reading by
long press SAVE. When you use the probes to measure a new stable reading that
is higher than the minimum trigger threshold, the meter will automatically save it. OL
Reading won't be saved. You can see the current number of data entries by the number
displayed above. When the maximum data storage limit is reached, a "Memory FULL"
warning will appear.
• Data Logger
You can record a lot of reading to memory in a long time, then analyze and plot graph.
The meter can store maximum 40,000 data in memory. The recorded data amount
shows on the secondary display. When the LOG function starts recording, a icon
will appear in the top left corner of the screen.
In LOG function, You can setup the record rate of logger. Press the INTERVAL button to
adjust using the UP and DOWN buttons.The record rate can be set from 1 sec and 600
sec. The error of timer is less than 3 seconds per hour.
9