Herunterladen Diese Seite drucken

Optos P200 Einführungshandbuch Seite 35

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 45
hibernation mode. Press
again.
7.7 How do I clear a Light Source Error?
Light Source Errors occur when the laser management system detects a
problem with the laser system. This is normally a temporary problem and
usually can be resolved by restarting the scan head. The scan head must be
switched off and on again to clear the Light Source Error state. As a safety
measure, no images can be captured until the problem has been resolved.
If you receive this message perform a full system restart, see How do I restart
the system? on the previous page .
The most common cause of Light Source Errors is trying to capture an image
before the lasers have fully warmed up. Wait at least 30 minutes before
imaging.
If the Light Source Error persists contact Optos and supply the
see Contact us on page 31 .
7.8 What should I do if the PC drive is full?
Ask your System Administrator to:
Empty the PC Recycle Bin.
l
Empty the Temporary Internet files.
l
7.9 What should I do if power is lost?
If power is lost to the Capture PC or the scan head, you will need to perform a
full system restart.
Check power is on and follow the full system restart procedure, see How do I
restart the system? on the previous page .
7.10 Will the software be updated?
Periodically Optos will supply software updates. You will be informed when
these are available and installation instructions will be provided for each update.
7.11 What screen resolution should I use to
review images?
The recommended screen resolution is 1280 x 1024 pixels, true color.
7.12 What should I do if artifacts remain on the
images after cleaning the main mirror?
If you have cleaned the mirror following the instructions given in the Main Mirror
Cleaning Procedure, please contact Optos for assistance, see Contact us on
page 31 .
Part Number: G95990/9GWE
Copyright 2014, Optos plc. Allrights reserved.
Chapter 7 - Troubleshooting
[Esc]
on the keyboard to activate the PC
Status
number,
Page 29 of 34
English

Werbung

loading

Diese Anleitung auch für:

200dx