Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Chapter 4 - Getting Started
If the PC monitor is switched on, but the screen is blank,
l
check that the PC is switched on.
The Capture PC should be powered from the scan head
l
table. Do not switch off the table's power supply unless told
to do so by Optos.
The Viewing PCs can only access image files if the PC that
l
stores them is switched on; this PC is usually the Capture
PC. The scan head does not need to be switched on if you
are only using the Capture PC to view stored images.
4.
Login to the Capture PC. You may need to press
keys simultaneously to display the Login screen. Enter your
Windows username and password in the
default username is "
All passwords are case sensitive.
5.
Capture
The
while the software is starting up. If the
run automatically, select
Capture
.
Do not close down the
need to run another application on the desktop, minimize the
Capture
application rather than closing it.
6.
If you have additional Viewing PCs, switch on and login to each one.
4.2 Viewing PC
Captured images are reviewed using the Review features. You need to login to
the Viewing PCs to access the patient details and images stored on the system.
Usually, Viewing PCs will have been logged off at the end of each day. To login
to a Viewing PC:
1.
[Ctrl]+[Alt]+[Del]
Press
2.
Type your username and password. Click
3.
Start menu > All Programs > optos V2 Vantage > Review
Select
Review
run the
4.3 Closing the system each day
The system must be closed down properly each day by shutting down the scan
head and closing the system.
Turning off the isolation transformer will stop the power supply to the scan head
and Capture PC. It is important before doing this that the PC is shut down in the
correct manner – in order to protect the integrity of information on the disk
drives.
Page 16 of 34
English
P200
" and the default password is "
application starts automatically. The logo is displayed
Capture
Start > Programs > Optos V2 Vantage >
Capture
application during the day. If you
Unlock Computer
to display the
application.
[Ctrl]+[Alt]+[Delete]
Login
dialog box. The
a1010
".
application does not
dialog box.
OK
.
to
Part Number: G95990/9GWE
Copyright 2014, Optos plc. Allrights reserved.
Werbung
