Inhaltsverzeichnis
Werbung
Connecting the
appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior.
See Cleaning the appliance" section.
The socket should be freely accessible.
Connect the appliance only to 220-240 V/
50 Hz AC current via a socket which has
been properly installed.
The socket must be fused with a 10 to
16 A fuse.
If the appliance is to be operated in a
non European country, check on the
rating plate whether the indicated voltage
and current type correspond to the values
of your mains supply. The rating plate is
situated in the bottom left hand side of
the appliance. The power cord may be
replaced by a technician only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
Switching on the
appliance
Press the On/Off button. Fig. 1/8
A warning signal sounds and alarm button
flashes.
Press the alarm" button. Fig. 2/3
The warning signal switches off.
The alarm button remains lit until the set
freezer compartment temperature has
been reached.
If the door is open, the interior light in the
refrigerator compartment is lit up.
The factory has recommended the
following temperatures:
Refrigerator compartment:
Freezer compartment:
Operating tips
S The fully automatic No Frost system
keeps the freezer compartment and
refrigerator compartment free of ice.
Defrosting is not required.
S The sides of the housing are sometimes
heated slightly. This prevents
condensation in the area of the door
seal.
S If you cannot open the freezer
compartment door immediately after
closing it, wait 2 3 minutes until the
partial vacuum has equalised.
en
+4 °C
-18 °C
27
Werbung
Inhaltsverzeichnis
