Criteria For The Installation Loca- Tion; Preparing The Appliance For The First Time; Connecting The Appliance To The Electricity Supply - Siemens KI51F Serie Gebrauchsanleitung

en Installation and connection
Prepare the appliance for first use.
3.
→ Page 38
Electrically connect the appliance.
4.
→ Page 38
Criteria for the installation loca-
tion
Follow these instructions when in-
stalling your appliance.
WARNING
Risk of explosion!
If the appliance is in a space that is
too small, a leak in the refrigeration
circuit may result in a flammable mix-
ture of gas and air.
Only install the appliance in a
▶
space with a volume of at least
3
1 m per 8 g refrigerant. The
volume of refrigerant is indicated
on the rating plate. → Fig.
The weight of the appliance ex works
may be up to 55 kg depending on
the model.
The subfloor must be of sufficient sta-
bility to bear the weight of the appli-
ance.
Permitted room temperature
The permitted room temperature de-
pends on the appliance's climate
class.
The climate class can be found on
the rating plate. → Fig.
Climate class Permitted room temperat-
ure
SN 10 °C to 32 °C
N 16 °C to 32 °C
ST 16 °C to 38 °C
T 16 °C to 43 °C
The appliance is fully functional within
the permitted room temperature.
38
/
1 7
/
1
7
If an appliance with climate class SN
is operated at colder room temperat-
ures, the appliance will not be dam-
aged up to a room temperature of
5 °C.
Niche dimensions
Observe the niche dimensions if you
install your appliance in the furniture
recess. If this is not the case, prob-
lems may occur when installing the
appliance.
Niche depth
Install the appliance in the recom-
mended niche depth of 560 mm.
If the niche depth is smaller, the en-
ergy consumption increases slightly.
The niche depth must be a minimum
550 mm.
Niche width
An inside niche width of at least
560 mm is required for the appli-
ance.
Preparing the appliance for the
first time
Remove the informative material.
1.
Remove the protective foil and
2.
transit bolts, e.g. remove the ad-
hesive strips and carton.
Clean the appliance for the first
3.
time. → Page 43
Connecting the appliance to the
electricity supply
Insert the mains plug of the appli-
1.
ance's power cable in a socket
nearby.
The connection data of the appli-
ance can be found on the rating
plate. → Fig.
Check the mains plug is inserted
2.
properly.
a The appliance is now ready for
use.
/
1 7