EN
The centrifuge must not be operated with highly corrosive substances which could impair the mechanical integrity
of rotors, hangers and accessories.
Repairs must only be carried out by personnel authorised to do so by the manufacturer.
Only original spare parts and original accessories licensed by the Andreas Hettich GmbH & Co. KG company are
allowed to be utilised.
Carbon brush change must be carried out by authorised and qualified personnel.
The following safety regulations apply:
EN / IEC 61010-1 and EN / IEC 61010-2-020 as well as their national deviations.
The safe operation and reliability of the centrifuge can only be guaranteed if:
the centrifuge is operated in accordance with the operating instructions,
the electrical installation on the site where the centrifuge is installed conforms to the demands of EN / IEC
stipulations,
prescribed tests to BGV A1, BGR 500 are carried out by an expert.
5
Symbol meanings
Symbol on the device:
Attention, general hazard area.
Before using the device, make sure you read the operating instructions and observe the safety
information!
Symbol in this document:
Attention, general hazard area.
This symbol refers to safety relevant warnings and indicates possibly dangerous situations.
The non-adherence to these warnings can lead to material damage and injury to personal.
Symbol on the device and in this document:
Beware of biohazard.
Symbol in this document:
This symbol refers to important circumstances.
Symbol on the device and in this document:
Symbol for the separate collection of electric and electronic devices according to the guideline
2002/96/EG (WEEE). The device belongs to Group 8 (medical devices).
Applies in the countries of the European Union, as well as in Norway and Switzerland.
6
Delivery checklist
The following items and accessories are delivered with the centrifuge:
1
Connecting cable
2
Fuses
1
Notes on moving the equipment safely
1
Operating instructions
2
Carbon brushes
Carbon brush change must be carried out by authorised and qualified personnel.
The model EBA 20 is supplied complete with angle-rotor 8x15 ml.
For round-bottomed tubes no rubber inserts are necessary.
Adapters for various types of blood colleting tubes can be offered on request.
24/59