Scheppach 7906100718 Originalbetriebsanleitung Seite 25

Additional safety instructions for pneumatic prod-
ucts
• Compressed air can cause serious injuries:
• When the machine is not in use, before replacing
accessories or when carrying out repair work, al-
ways shut off the air supply, depressurise the air
hose and disconnect the machine from the com-
pressed air supply.
• Never direct the airflow towards yourself or to-
wards other people.
• Hoses whipping around can cause serious injuries.
Therefore, always check that the hoses and their
fasteners are undamaged and have not loosened
off.
• Cold air must be drawn away from the hands.
• Do not use quick connectors on the tool mount of
impact and pulse screwdrivers. For threaded hose
connections, use only those made of hardened steel
(or a material of comparable impact resistance).
• If universal swivel couplings (claw couplings) are
used, locking pins must be inserted and use Whip-
check hose locks to provide protection in the event
of a failure of the connection of the hose to the ma-
chine or of hoses to each other.
• Make sure that the maximum pressure indicated on
the machine is not exceeded.
• In torque-controlled machines with continuous ro-
tation, the air pressure has a safety-relevant effect
on the performance. Therefore, requirements for the
length and diameter of the hose must be specified.
• Never carry air-operated machines by the hose.
6. Residual risks
The product has been built according to state-of-the-
art and the recognised technical safety rules. However,
individual residual risks can arise during operation.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with the
operating manual as a whole are observed.
• Lung damage if suitable dust protection mask is not
worn.
• Hearing damage if suitable hearing protection is not
worn.
• Damage to health resulting from hand/arm vibration
if the device is used over an extended period of time
or if it is not properly operated and maintained.
7. Technical data
Max. torque
Working pressure
Speed
Weight
Subject to technical changes!
Air supply:
Via a compressed air source with pressure adjustment
option such as a compressor. Also read the mainte-
nance and care section before commissioning.
Settings for the work:
Set a maximum working pressure of 6.3 bar on your
compressed air supply.
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Noise data
Sound power level L
Sound pressure level L
Uncertainty K
Additional information
Warning!
The vibration emission value specified has been meas-
ured in accordance with a standardised test procedure
and may change depending on the type and manner in
which the device is used and may be above the speci-
fied value in exceptional cases.
The specified vibration emission value can be used to
compare one device with other.
The specified vibration emission value can also be
used for an initial assessment of the impairment.
Keep the noise level and vibration to a minimum!
• Only use faultless devices.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
www.scheppach.com
WA
pA
wa/pA
68 Nm
max. 6.3 bar
160 rpm
1.2 kg
101.8 dB
90.8 dB
3 dB
GB | 25