Charging The Shaver - Panasonic ES-LT31 Bedienungsanleitung

Using the lock ring
Use the lock ring to lock or unlock the power switch.
Rotate the lock ring until it clicks.
Rotate the lock ring to " " to unlock the power
switch:
Used when shaving, washing the shaver, lubricating
the shaver.
Rotate the lock ring to " " to lock the power
switch:
Used when carrying the shaver.
Charge
Charging the shaver
1
1
Insert the appliance plug into the
shaver.
2
2
Plug in the AC adaptor into a
household outlet.
•►Turn the shaver off before inserting.
•►Charging is completed after approx. 1 hour.
You cannot operate the shaver while charging.
4
Reading lamps when charging
While charging
The charge status lamp (
The number of the battery
capacity lamp will increase as
charging progresses.
•►After charging is completed, turning the power switch ON with
the shaver plugged in will cause all the lamps to light up and then
2
turn off after 5 seconds. This shows that the shaver is fully
charged.
•►Recommended ambient temperature for charging is 5‑35 °C. The
battery may not charge properly or not at all under extreme low
1
or high temperatures.
The charge status lamp (
with charging.
•►When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charge status lamp (
may not glow. It will eventually glow if kept connected.
After charging is completed
)
glows.
All the lamps will light up and
then turn off after 5 seconds.
) will blink when there is a problem
)