Parkside PBEB 52 A1 Originalbetriebsanleitung Seite 13

• Maintain and clean the product at regular inter-
vals.
• Adapt your working methods to the product.
• Do not overload the product.
• Have the product checked if necessary.
• Switch the product off if it is not in use.
• Wear gloves.
Warning!
In case of extended working periods, the operating
personnel may suffer circulatory disturbances in
their hands (vibration white finger) due to vibrations.
Raynaud's syndrome is a vascular disease that
causes the small blood vessels on the fingers and
toes to cramp in spasms. The affected areas are no
longer supplied with sufficient blood and therefore
appear extremely pale. The frequent use of vibrating
products can cause nerve damage in people whose
circulation is impaired (e.g. smokers, diabetics).
If you notice unusual adverse effects, stop working
immediately and seek medical advice.
Observe the following information to reduce haz-
ards:
• Keep your body and especially your hands warm
in cold weather.
• Take regular breaks and move your hands to pro-
mote circulation.
• Make sure that the machine emits the least vibra-
tion possible through regular maintenance and
fixed parts on the product.
The specified sound levels have been measured in
accordance with a standardised test procedure and
can be used to compare different tools with one an-
other.
In addition, these values are suitable for estimating
the stresses for the user resulting from the noise in
advance.
m WARNING
The vibration emission value can vary from the spec-
ified value during actual use, depending on the type
and the manner in which the product is used. Try to
minimise stress from vibrations as low as possible.
Some examples of means for reducing the vibration
stress are wearing gloves while using the tool and
limiting work time.
In doing so, all parts of the operating cycle must be
taken into account (such as times in which the prod-
uct is switched off or times in which it is switched on,
but is not running under a load).
Keep the noise level and vibration to a minimum!
9. Unpacking
• Open the packaging and carefully remove the
product.
• Remove the packaging material, as well as the
packaging and transport safety devices (if pre-
sent).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for trans-
port damage. In the event of complaints the car-
rier must be informed immediately. Later claims
will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means
of the operating manual before using for the first
time.
• With accessories as well as wearing parts and
replacement parts use only original parts. Spare
parts can be obtained from your specialist dealer.
• When ordering please provide our article number
as well as type and year of manufacture for the
product.
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plastic
bags, films or small parts! There is a danger of chok-
ing or suffocating!
10. Assembly
Your product is not completely assembled for pack-
aging reasons.
10.1 Inserting the drill (Fig. 1 + 2 + 8-10)
If drill are not mounted correctly, this can result in
serious accidents! Before starting work, check that
the inserted drill is firmly seated.
1. Place the engine housing of the earth auger on
a workbench.
GB/IE/NI/CY/MT 9