Parkside Performance PABSP 20 Li C4 Originalbetriebsanleitung Seite 19

Belt clip
(Fig . J)
m CAUTION! Risk of injury!
Before hanging the product in the belt:
u
Push the rotation direction switch
the centre position (lock) . This prevents
the product from being switched on
accidentally .
NOTE
The belt clip allows the tool to be
u [ 9 ]
hooked on belt or pocket .
The belt clip is not assembled upon
u
delivery .
The belt clip can be mounted on either side
u
of a belt .
For the assembly of the belt clip a cross tip
u
screwdriver is required .
1 . Use a cross tip screwdriver to loosen the
screw of the belt clip
2 . Insert the belt clip on either side of the
product .
3 . Use a cross tip screwdriver to tighten the
screw .
˜ Cleaning and care
m WARNING!
Always switch the product off, remove
the battery pack
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product .
o
The product must always be kept clean, dry
o
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help ensure
o
safe use and prolong the life of the product .
to
5 ] [
.
9 ] [
and let the
10 ] [
Clean the product with a dry cloth . Use a soft
o
brush for areas that are hard to reach .
In particular clean the air vents after every
o
use with a cloth and soft brush .
The vents must always be clear .
o
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces .
˜ Maintenance
Before and after each use, check the product
o
and accessories (e .g . accessory tools) for
wear and damage . If required, exchange
them for new ones as described in this
instruction manual . Observe the technical
requirements (see "Technical data") .
˜ Repair
This product does not contain any parts
o
that can be repaired by the user . Contact
an authorised service centre or a similarly
qualified person to have it checked and
repaired .
˜ Storage
Push the rotation direction switch
o
centre position to lock the on/off switch
Clean the product as described above .
o
Store the product and its accessories in a
o
dark, dry, frost-free, well-ventilated place .
Always store the product in a place that is
o
inaccessible to children . The ideal long term
storage (longer than 3 months) temperature is
between +20 and +26 °C .
Guide the drill bit into the bit holder
o
Store the product in its carrying case
o
Battery pack advice
Only store the battery pack
o
charged . The battery pack should be charged
to 40 to 60 % (red and orange LED in the
charge indicator
14 ] [
for extended periods .
to the
5 ] [
.
6 ] [
.
8 ] [
.
19 ] [
partially
[ 10 ]
light up) before storing
GB 17