Parkside Performance PABSP 20 Li C4 Originalbetriebsanleitung Seite 16

Attaching the battery pack: Align the
o
battery pack to the handle and slide it into
[ 10 ]
it . Ensure it clicks noticeably in place .
The battery pack can only be inserted into the
product in one direction .
˜ Checking the battery pack
charging level
(Fig . B)
Check battery pack charge level: Press the
o
button . The charging level LEDs
13 ] [
light up:
LED
14 ] [
Red/orange/green
Red/orange
Red
˜ Charging the battery pack
(Fig . C)
NOTE
The battery pack
u
any time without reducing the life .
Interrupting the charging process does not
u
damage the battery pack
Charge the battery pack
o
when it is at medium or low charging level .
The charging control LEDs (green
o
red ) indicate the status of the charger
18 ] [
and the battery pack
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
14 GB
[ 14 ]
Charging level
Maximum
Medium
Low
may be charged at
[ 10 ]
.
[ 10 ]
before operation
10 ] [
and
[ 17 ]
:
10 ] [
Status
Battery pack charges
Battery pack fully
charged
Battery pack defective
Battery pack too cold
or too warm
Charger ready
1 . Insert the battery pack
charger
[ 15 ]
2 . Connect the power cord with power plug
of the charger
3 . When the battery pack
charged: Remove the battery pack from
the charger
plug of the charger from the socket .
16 ] [
˜ Attaching/removing the
accessory tool
m CAUTION! Risk of injury!
Accessory tools can be sharp and
may become hot during use . Always
wear protective gloves when handling
accessory tools!
m WARNING!
Always switch the product off, remove
the battery pack
product cool down before making any
adjustments!
m CAUTION! Risk of injury!
Keep your hands away from the accessory
u
tool when the product is in operation .
After the product has been switched off, the
u
accessory tool continues moving for some
time . Do not touch the accessory tool and
do not attempt to brake it .
15 ] [
This product is equipped with an automatic
spindle lock to open or close the chuck
the chuck ring
2 ] [
1 . Open the chuck
a counter-clockwise direction (Fig . E) .
2 . Insert a suitable accessory tool into the
chuck as deep as required .
1 ] [
3 . Close the chuck
tool in position . Turn the chuck ring
clockwise direction .
into the
10 ] [
.
to the socket .
[ 15 ]
is fully
10 ] [
. Then disconnect the power
15 ] [
and let the
[ 10 ]
.
: Turn the chuck ring
1 ] [
: Hold the accessory
[ 1 ]
16 ] [
with
1 ] [
in
2 ] [
in a
2 ] [