probst XS-JET-80-GRABO Betriebsanleitung Seite 37

Operation
4.2 Device operation
4.2.1 Changing the suction plate
•
Pull back the four locking pins of the
suction plate one after the other until you
hear a click and the locking pins are
secured.
•
Hold the XS-JET-80-GRABO appliance
by the handle and lift the appliance off
the suction plate.
•
Place the XS-JET-80-GRABO device on
the suction plate of your choice.
•
Hold the XS-JET-80-GRABO device in
position and press the buttons on the
four suction plate locking pins.
•
The locking pins release with a click and
the suction plate is attached to the XS-
JET-80-GRABO.
•
If the suction plate is not fully locked,
press on the XS-JET-80- GRABO so that
the locking pins can engage.
NOTE: Always ensure that the suction plate is
firmly attached to the appliance before using
the XS-JET-80-GRABO appliance.
58500018 13 / 21 GB