Silvercrest SPDVD 1A1 Bedienungs- Und Sicherheitshinweise Seite 56

Inserting/replacing the
battery
Push the tab of the battery
[
compartment
the battery compartment.
Replace with a new 3 V type
CR2025 battery. The + marking on the
battery must match the + marking on the
battery compartment.
Close the battery compartment properly.
The tab of the battery compartment must
click into place.
Connecting the power
supply
In order to use the product, you must
connect it to the power supply.
You can connect the product to a socket-
outlet or operate it using the integrated
rechargeable battery or the car adaptor.
m
ATTENTION! Switch off the product
before connecting it to the power supply.
Do not switch on the product until all
connections have been established.
]
to the middle. Pull out
Mains power operation
Insert the plug of the supplied power
[ ]
adaptor into the DC IN socket
on the side of the DVD player A.
Plug the power adaptor
socket-outlet that is always within easy
reach.
Operation using the car adaptor
m
CAUTION! The car adaptor
suitable for use with a 24 V on-board
power socket.
Insert the plug of the supplied car
[ ]
adaptor into the DC IN socket
on the side of the DVD player A.
Connect the car adaptor
suitable 12 V on-board socket, e.g. the
car's cigarette lighter.
Charging the DVD player
battery
Once you have connected the power
supply, the integrated rechargeable
battery in the DVD player A will charge
automatically. During charging, the
green charging LED
soon as the battery is fully charged, the
charging LED lights up.
NOTES:
If the DVD player A is not going to be
used for some time, the battery should
be recharged at regular intervals to
maintain battery performance.
If the battery is low,
is displayed on the bottom left of the
screen. Charge the battery immediately
in such case.
9 ] [
[ ]
into a
[ ]
is not
9 ] [
[ ]
to a
[ ]
flashes. As
Low Battery
GB/IE 55