Turn Off Pid Display Feature; Preparing Coffee; Dispensing Of Hot Water; Dispensing Of Steam - Profitec Pro 700 Bedienungsanleitung

6.3 Turn off PID display feature

There is the option to turn the PID display off: Press the
appear on the display, which indicates that the machine is still turned on. The display will be turned on
+
again by pressing the

6.4 Preparing coffee

Use the portafilter with 1 spout and the corresponding filter (1 cup) for the preparation of 1 cup. Use the
portafilter with 2 spouts and the big filter (2 cups) for the preparation of 2 cups. Make sure that the filter is
firmly locked into the portafilter.
Fill the ground coffee (with the respective grind for espresso or Café Crème) into the filter (approx. 7 g –
9 g).
Compress the ground coffee with the tamper. Clamp the portafilter firmly into the brew group.
Place the cup under the spout of the portafilter (for the preparation of 2 cups, put 1 cup under each spout).
Now move the brew lever into the upper position to start the brewing process. The timer on the PID-
display indicates the brewing time in seconds. In general, the brewing time should be around 23 to 25
seconds.
The volume for a single espresso is circa 25 to 30 ml. Place the brew lever back into the original position
once the desired volume is reached.
The remaining pressure/water will be discharged into the drip tray by the lower part of the brew group
cylinder.
Caution!
If the group lever is not moved into the lower position properly, hot water and grounds will
squirt out of the brew group while taking out the portafilter. This may cause injuries.
• Only freshly ground coffee allows for an optimal coffee result. Therefore, use a
professional coffee grinder. In our assortment you will find several professional and
compact coffee grinders.
• We recommend to use a stainless steel tamper with a diameter of 58 mm for optimum
tamping.

6.5 Dispensing of hot water

1 To dispense hot water the steam boiler has to be switched on. Press the right switch behind the drip
tray in position 'I'.
2 Place a suitable vessel (with heat-insulated grip) underneath the hot water wand. Now you can
dispense hot water (e.g. for tea). When dispensing large amounts of water, it is advisable to turn the
machine off so that no cold water is pumped anymore.
3 After having dispensed hot water, turn the machine back on. The boiler is automatically refilled with
fresh water.
When the machine is switched off, more hot water can be dispensed.
However, one does not necessarily have to switch off the machine for dispensing hot
water.
Risk of injury
Always keep the hot water nozzle underneath the surface of the water while heating in
order to avoid splashing.

6.6 Dispensing of steam

The PRO700 makes it possible to generate large amounts of steam in order to heat or froth beverages, e.
g. milk or punch. It is a professional and compact espresso coffee machine with an enormous steam
volume. Therfore, within a few seconds, you can prepare milk froth. Please pay attention to the
instructions below. Do not bring the milk to a boil, otherwise frothing milk will not be possible.
Translation of the original German user manual
button once more.
+
button until the display turns off. A dot will
ENGLISH
34