Programming The Temperature Mode "O - Profitec Pro 700 Bedienungsanleitung

+
3. Press in order to progress to the submenu of 't1' and to change
the temperature value. The nominal temperature value is displayed.
4. Quickly press
the nominal temperature value.
5. Please wait a short while after having set the nominal temperature
value;
't1' will be displayed.
–
6. Press in order to display 't2' (steam boiler).
If you would like to change just 't2' and leave 't1' unchanged, press
after step 2 in order to progress directly to 't2' and skip 't1'. Continue
with step 7.
+
7. Press in order to progress to the submenu of 't2' and to change
the temperature value. The nominal temperature value is displayed.
8. Quickly press
the nominal temperature value.
9. Please wait a short while after having set the nominal temperature
value; 't1' will be displayed.
–
10. Press 2 x in order to leave the programming mode. The newly
programmed nominal temperatures are now saved. Both heaters are
now activated successively.
6.2.2

Programming the Temperature Mode "o"

You can also set whether the temperature values of t1 and t2 should be displayed in °C or °F.
To adjust this setting, proceed as follows:
+ –
1. Press and at the same time and "t1" will appear on the display.
–
2. Press the button
+
Press to enter the menu.
Translation of the original German user manual
–
to decrease
+
to increase
–
to decrease
+
to increase
twice. After t1, and t2, "o" appears on the display.
–
ENGLISH
32