Making Cold Milk Froth; Making Hot Milk Froth - Silvercrest IAN 276999 Bedienungsanleitung

7.5. Making cold milk froth


Insert whisk B (5) up to the stop on the drive shaft inside the canister (7).

Take the canister (7) off the base (11) and pour milk up to the MIN marking inside the canister
(7). The volume of the milk increases during the frothing process. Only pour milk up to the
lower MAX marking in order to prevent the milk froth from overflowing.

Place the lid (2) onto the canister (7).

Place the canister (7) onto the base (11).

Press the On/Off button (10) for approximately three seconds. The blue LED (8) lights up and
whisk B (5) begins to turn. The process of creating milk froth begins.

As soon as the milk froth is ready, the milk frother automatically switches off and the blue LED
(8) goes out.
You can stop the preparation process at any time by briefly pressing the On/Off
button (10).

Wait around 30 seconds until any remaining fluid milk settles at the bottom of the canister (7).

Lift the canister (7) off the base (11), remove the lid (2) and use the milk froth as you wish.

Wait two to three minutes before using the milk frother again.

7.6. Making hot milk froth


Insert whisk B (5) up to the stop on the drive shaft inside the canister (7).

Take the canister (7) off the base (11) and pour milk up to the MIN marking inside the canister
(7). The volume of the milk increases during the frothing process. Only pour milk up to the
lower MAX marking in order to prevent the milk froth from overflowing.

Place the lid (2) onto the canister (7).

Place the canister (7) onto the base (11).

Press the On/Off button (10). The red LED (9) lights up and whisk B (5) begins to turn. The
process of creating milk froth begins.

As soon as the milk froth is ready, the milk frother automatically switches off and the red LED
(9) goes out.
You can stop the preparation process at any time by briefly pressing the On/Off
button (10).

Wait around 30 seconds until any remaining fluid milk settles at the bottom of the canister (7).

Lift the canister (7) off the base (11), remove the lid (2) and use the milk froth as you wish.

Wait two to three minutes before using the milk frother again.
SilverCrest SMA 500 B1
English - 13