Herunterladen Inhalt Inhalt Diese Seite drucken

Tips On How To Make Good Milk Froth; Changing The Batteries - Silvercrest SMAS 3 A1 Bedienungsanleitung Und Sicherheitshinweise

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Dip the whisk (5) into the milk until it is slightly above the base of the container.
Press down on the on/off button (1). The whisk (5) will rotate. The LED ring (4) lights up during
operation.
Swirl in a circular motion until you have created the desired volume of foam. While swirling,
slowly and steadily raise the whisk (5). The whisk (5) must always remain within the milk.
Let go of the on/off button (1) in order to switch off the milk frother. The LED ring (4) will turn
off.
Take the whisk (5) out of the milk as soon as it has come to a standstill.
Remove the milk foam.
Clean the milk frother as described in the 'Cleaning' section.

7.3. Tips on how to make good milk froth

 We recommend using cow's milk. Other types of milk behave differently during the frothing
process.
 It is best to use milk with a fat content of between 1.5 and 3.5 per cent. Low-fat milk and
skimmed milk do not froth well.
 The milk should be cool.
 If you want to make warm milk froth, the milk should not exceed a temperature of 60°C.
Otherwise the milk does not froth.
 If you find the milk froth to be too liquidy, we recommend leaving it to rest for around 30
seconds. During this time, the liquid milk can sink down and the milk froth achieves a better
consistency.

7.4. Changing the batteries

If the milk frother's performance declines or the device stops working, you need to replace the
batteries. Proceed as follows to change the ear cushions:
Open the battery compartment (2) by twisting the lid anti-clockwise and removing it.
Remove the old batteries and dispose of them in an environmentally friendly manner.
Insert the new batteries with the correct polarity (note the + and - signs). The polarity is marked
on the batteries and in the battery compartment (2). Do not use different batteries (old and
new, alkaline and carbon etc.) at the same time.
Turn the lid clockwise on the battery compartment (2) until it is hand-tight in order to close the
battery compartment (2).
SilverCrest SMAS 3 A1
English - 23

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis