Making Cold Frothed Milk - Silvercrest SMAI 550 A1 Bedienungsanleitung

Making cold frothed milk

1) If not yet attached: Insert the spiral coil
stirrer
2) Remove the jug
milk to reach MIN mark inside the jug
MAX mark
Otherwise, the appliance may overflow. When frothed, the volume of the
milk increases significantly!
NOTE
► If there is not enough milk in the appliance, all three red symbols
and
you will hear 9 beeps. Add milk. Observe the MIN mark!
3) Place the jug
4) Put on the lid
5) Press the On/Off / programme selection button
symbol
6) The appliance switches off as soon as the milk is frothed. The symbol
will flash and you will hear a beep.
NOTE
► If you wish to stop the preparation process before completion, press the
On/Off / programme selection button
process, press the On/Off / programme selection button
again until the
restart.
7) Wait about 30 seconds. During this time the still-liquid milk flows to the
bottom.
8) Remove the lid
SMAI 550 A1
.
from the base
(350 ml).
will flash simultaneously shortly after you start the appliance and
on the base
with the stirrer
lights up. The whisk will start rotating. It froths the milk.
symbol
and pour the milk froth into the desired container.
into the slots of the whisk on the
and add the cold milk. Add enough
(130 ml). Never exceed the lower
.
.
. To restart the preparation
lights up. The preparation process will
,
4 times until the
4 times
GB │ IE │ 27 ■