Privacy Policy; Disconnecting The Device And Deleting Data From The App; Problems­with­the­app?­-­Faq - Parkside Performance Ppsbsa 20-Li A1 Originalbetriebsanleitung

- The Tool Rotation Speed indicates the
revolutions per minute
- The current level is shown and can be
changed, instead of pressing the gear
selection switch (5)
- With the kickback control switch, you
can turn the kickback control on and off
- The device's operating mode can be
selected:­Power,­Professional­and­ECO
- With the lamp switch, you can turn the
work light on and off
- With LED brightness, you can control the
brightness of the work light by moving
the bar from 1% to 100%
- With the LED shutoff delay, you can set
how long the work light stays on after
the On/Off switch is released
-­ You­can­find­the­device's­use time
-­ You­can­find­how­often­the­device­has­
overheated
-­ You­can­find­how­often­the­device­has­
been blocked
-­ You­can­find­the­tool overcurrent times
- A red dot next to the firmware version
indicates that an update is available.
The update can be installed by tapping
the­firmware­version
- Via factory setting, you can restore the
factory settings. All stored data are
deleted.
Swipe from left to right to reach the smart
battery overview page. Here, you can:
- Lock battery
- Battery work mode
-­ PUSH­notifications­(overtemperature­
and­battery­identifier)
- Degrees Fahrenheit/Degrees Celsius
switchover
- Information
- Statistics
Display in real time as graphs:
- Capacity
- Discharge current
- Charging current
- Temperature

Privacy policy

The complete privacy policy can be found
­in­the­field­
on the tab
Disconnecting the device and
deleting data from the app
To disconnect the smart battery/charger
and delete data:
"At home",­select­the­
1. On the tab
device that you want to remove and
whose data you want to delete.
2. Select the icon in the top right.
3. Select „Remove device".
4. To delete the data, select „Disconnect
and delete data". If you just want to dis-
connect the device without deleting the
data, select "Disconnect".
Disconnect a Performance device coupled
via a smart battery and delete data:
1. Select the tab
2. Select the smart battery that you are
using for the Performance device. The
symbol indicates that the smart battery
is connected to a Performance device.
3. Select Factory setting at the very bottom
of the settings. The factory settings are
restored. All stored data are deleted.
Problems­with­the­app?­-­FAQ
1. Select the battery you have questions
about from the device list.
2. Select the icon in the top right.
3. Select the option "FAQ"­(Frequently­
Asked­Questions).
GB MT
"Privacy policy".
"At home".
35