Mounting/Removing The Auxiliary Handle; Switching On/Off; Connecting The Device With The Lidl Home App - Parkside Performance Ppsbsa 20-Li A1 Originalbetriebsanleitung

Mounting/removing the
auxiliary handle
Operate the device only with
a mounted auxiliary hand-
le (21).
Mounting the auxiliary handle
1. Turn the handle (20) of the auxiliary
handle (21) in an anticlockwise direc-
tion.
2. Press the handle (20) towards the ex-
tension (19) and hold it in position.
This extends the loop (17).
3. Slide the loop (17) on the auxiliary
handle (21) over the drill chuck (2).
4. Release the pressed handle (20). Make
sure (by slightly rotating) that the au-
xiliary handle (21) is engaged in the
notches on the device housing.
5. Tighten the handle (20) of the auxiliary
handle (21) by turning it in a clockwise
direction.
Removing the auxiliary handle
1. Turn the handle (20) of the additional
handle (21) clockwise.
2. Press the handle (20) towards the ex-
tension (19) and hold it in position.
3. Remove the auxiliary handle (21) from
the device by pulling the loop (17) on
the auxiliary handle (21) over the drill
chuck (2).
The­butterfly­screw­(18)­lets­you­fix­
the depth stop (23).

Switching on/off

By using the on/off switch (16) you can
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
With the gear selection switch (5) you pre-
select a speed, see the section "Gear selec-
tion".­With­the­slip­clutch­selection­switch­
(4), you can choose the drilling
or screw operating mode, see the sec-
tion­"Switching­the­slip­clutch­on/off".
We recommend running the screw opera-
ting mode in 1st gear.
1. Press the on/off switch (16) to start the
device.­The­LED­work­light­(14)­lights­
up during operation and approximately
10 seconds after you release the On/
Off switch (16).
The­lighting­duration­of­the­LED­
work light (14) can be set in the
Lidl Home App, see section "Connec-
ting the device with the Lidl Home App
>­App­functions".
2. To turn it off, release the on/off
switch (16).­When­you­move­the­direc-
tion switch (6) to the middle position,
the device is secured against being
switched on.
During breaks in work, the device
can be hung from a belt, using the
integral metal clip (9). Take care to
ensure that the device is switched
off and secured against accidental
activation.
The metal clip is also suitable for
opening bottles with bottle caps.
Connecting the device
with the Lidl Home App
The device can only be connected to
the Lidl Home App if you are using it
with a Smart Performance battery.
Upgrading­the­firmware­can­change­
the features of the app.
GB MT
33