Set The Direction Of Rotation; Torque Setting; Switching The Slip Clutch On/Off; Impact Drilling - Parkside Performance Ppsbsa 20-Li A1 Originalbetriebsanleitung

GB MT
Set the direction of
rotation
You­can­select­the­direction­of­rotation­
with the direction switch (clockwise and
anticlockwise direction) and secure the
device against accidental start up.
The arrow on the direction switch indicates
the working direction.
1. Wait for the device to shut-down.
2. Push the direction switch (6) into the
desired position:
Clockwise direction:
To drill and screw in screws. Press the
direction switch to the left with the ar-
row pointing forwards
Counter-clockwise direction:
To unscrew screws. Press the direction
switch to the right with the arrow poin-
ting backwards
3. Switch lock: Bring direction switch to
neutral position.
The direction changed may only be
performed in standstill mode.

Torque setting

You­can­preset­the­maximum­torque­by­ro-
tating the torque adjustment ring (3).
25 torque levels are provided.
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 --> lowest torque,
Step 25 --> highest torque.
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
32
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.
Switching the slip clutch on/
off
The slip clutch may only be switched on/
off when at a standstill.
To use the screw operating mode, switch
the slip clutch on.
∙
Set the slip clutch selection switch (4)
so that the screw symbol
the majority of the vision panel.
To use the drill operating mode, switch the
slip clutch off.
∙
Set the slip clutch selection switch (4)
so that the drilling symbol
the majority of the vision panel.

Impact drilling

Set the slip clutch selector switch (4) to

Tool change

1. Rotate the keyless chuck (2) counter-
clockwise, until the drill chuck aper-
ture (1)­is­large­enough­to­accommo-
date the tool.
2. Push the tool as far as possible into the
keyless chuck (2).
3. Rotate the chuck clockwise to clamp
the­tool­firmly.
4. To remove the tool again, rotate the
keyless chuck (2) and pull out the tool.
At the centre of the bottom rear of
the­handgrip­(7)­you­will­find­a­
magnetic bit holder (8) where you
can secure a bit you don't currently
need.
takes up
takes up
.