Checking The Battery Charge Level; Recharging The Battery; Inserting / Removing The Device's Battery Pack; Choice Of Gear - Parkside Performance Ppsbsa 20-Li A1 Originalbetriebsanleitung

operating mode on the device. See
also the chapter "Switching the slip
clutch­on/off"
Checking the battery
charge level
Press the soft button (10) on the batte-
ry (11).­The­charge­level­of­the­battery (11)­
is indicated by illumination of the corre-
sponding­LEDs­on­the­battery­charge­level­
indicator (12).
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red
=> Battery needs

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (11) when
the­red­LED­on­the­charge­status­indi-
cator (12) is on.
1. Remove the battery (11) from the ap-
pliance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (11) in the charging
compartment of the battery char-
ger (24).­
3. Plug the battery charger (24) into a
mains outlet.
4. Once charging is complete, disconnect
the charger (24) from the mains supply.
5. Remove the battery (11) from the char-
ger (24).
to be charged
Overview of the control display on
the charger (24):
Green LED lights up without battery
inserted: Charger ready.
Green LED lights up:
Battery such alleged charged.
Red LED lights up: Battery charging.
Red LED flashes: Battery overheated
Red + green LEDs flash:
Defective battery
Note the label on the device itself
for­the­LED­display­on­the­smart­
charger.
Inserting / removing the
device's battery pack
Inserting the battery pack:
1. Move the rotation direction switch (6)
onto its middle setting (lock).
2. Slide the foot of the device onto the bat-
tery pack (11) until it clicks into place.
Removing the battery pack:
1. Push the release button (13) and pull
the battery pack (11) out towards the
front of the device.

Choice of gear

Slide the gear selector (5) to 1 or 2,
corresponding to a low or high torque
selection.
1st gear .............................0-550 min
2nd gear .........................0-2200 min
A gear change may only be
performed in standstill mode!
GB MT
-1
-1
31