Residual Risks; Operation - Parkside Performance Ppsbsa 20-Li A1 Originalbetriebsanleitung

GB MT
insert tool or screws may come
into contact with hidden wiring.
Contact with a live wire can also cause
a charge in metal parts of the tool and
result in an electric shock.
2) Safety information for using
long drills
a) Do not work at a speed higher
than the maximum permissible
speed for the drill. Higher speeds
can cause the drill to bend slightly when
rotating freely without contact with the
workpiece and can also cause injury.
b) Always begin drilling at a low
speed and when the drill is in
contact with the workpiece. Hig-
her speeds can cause the drill to bend
slightly when rotating freely without
contact with the workpiece and can
also cause injury.
c) Do not apply excessive pressure
to the drill. Only apply pressure
lengthwise along the drill. Drills
can bend and break or cause a loss in
control, thus resulting in injuries.
3) Additional safety instructions
a) Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric shock
or­fire.

Residual Risks

Even­if­properly­operating­and­handling­this­
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Cuts
b)­ Ear­damage­if­working­without­ear­
protection.
30
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic­field­which,­under­certain­
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and the
manufacturer of their medical im-
plant before operating the machine.
Observe the safety informati-
on and notes on charging and
proper use as shown in the
instruction manual for your
battery and charger from the
Parkside X 20 V Team series.
A detailed description of the
charging process and further
information can be found in
the separate operating inst-
ructions.

Operation

Remove the battery from the
device to prevent accidental
operation. Risk of injury!
Ensure that the ambient tem-
perature does not exceed
50°C or fall below -20°C
during work.
Depending on whether you want to
use the drilling
ting mode, select the corresponding
or screw opera-