Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Restoring factory settings
9 Restoring factory settings
The factory settings of the device
can be restored. If you do this, you
will lose all your settings.
To restore the factory settings of the
Multi IO Box, please proceed as fol-
lows:
• Press and hold the system button
(A) for 4 seconds until the LED (A)
starts to quickly flash orange
(see
figure).
• Release the system button.
• Press and hold the system button
again for 4 seconds, until the LED
lights up green.
• Release the system button to finish
restoring the factory settings.
The device will perform a restart.
10 Maintenance and cleaning
The product does not require any
maintenance. Enlist the help of an
expert to carry out any repairs.
Clean the device using a soft, clean,
dry and lint-free cloth. Dampen the
cloth a little with lukewarm water to
remove more stubborn marks. Do not
use any detergents containing sol-
vents, as they could corrode the plastic
housing and label.
11 General information about
radio operation
Radio transmission is performed on
a non-exclusive transmission path,
which means that there is a possibility
of interference occurring. Interference
can also be caused by switching oper-
ations, electrical motors or defective
electrical devices.
The transmission range within
buildings can differ significantly
from that available in open space.
Besides the transmitting power
and the reception characteristics
of the receiver, environmental
factors such as humidity in the
vicinity play an important role, as
do on-site structural/screening
conditions.
eQ-3 AG, Maiburger Straße 29, 26789
Leer, Germany hereby declares that the
radio equipment type Homematic IP
HmIP-MIOB is compliant with Direc-
tive 2014/53/EU. The full text of the EU
declaration of conformity can be found
at
www.homematic-ip.com
30
Werbung
