probst SM-1200 Betriebsanleitung Seite 89

7 Operation
7.1.3 Protective equipment
The following protective equipment is required for operation:
•
Safety shoes safety class S1 or better
• Sturdy work gloves depending on the load
•
Industrial safety helmet according to EN 397
• Tight-fitting clothing
•
Use a hairnet if necessary.
CAUTION
High noise level due to leakage between load and suction pad
Hearing damage!
•
•
7.1.4 Using the lifting device properly
Improper use of the lifting device can endanger the operator and damage the product.
•
The main switch must remain switched on during the entire operation.
•
Do not let go of the operating handle during handling.
•
Always suck in the load at the center of gravity.
•
Keep an eye on the vacuum pressure gauge .
•
Handling must not be supported or hindered by additional external forces.
•
Do not pull, drag or drag loads at an angle.
• Avoid swinging the load.
• Only handle one load per lifting operation. Separate the loads if necessary.
• Only ever handle a load with one lifting device.
• Guide the lifting device as close to the ground as possible.
• Take off the load before long work breaks.
Always guide and handle the lifting device at an ergonomically favorable working height.
28 / 53
Measure the noise level with typical loads.
Depending on the load surface, noise levels may occur that require the wearing of hea-
ring protection .
EN - 30.30.01.04558 - 00 - 09/24