Resetting The Defaults - G&D DVIMUX8-USB Bedienungs Und Installationsanleitung Handbuch

Resetting the defaults

This function resets the default settings of the KVM switch.
IMPORTANT: Performing this function reactivates the default settings of the KVM
switch as shown on page 14.
How to reset the default settings:
1. Press Hotkey+Backspace
the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press the setup key listed below to reset the default settings:
D  reset default settings
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
2. Use the Arrow
3. Press Enter to reset the default settings.
4. Confirm the pop up security query with
Pressing the Q
(default: Ctrl+Backspace
« to switch to the setup menu.
#!
or Arrow keys to select the
key cancels the function.
) simultaneously to enable
Set System Defaults entry.
Enter .
G&D DVIMUX8-USB · 23
Configuration