Parkside Performance PSSAP 20 Li C4 Originalbetriebsanleitung Seite 23

6. Connect the battery pack to the Lidl Home
app (see "Connecting the product to the Lidl
Home app").
{Device info}
7. Select
(2201)" under {Battery}. The overview
page of the cordless sabre saw is displayed.
{Firmware
8. Select
firmware.
9. After successfully updating the firmware,
the connection with the cordless sabre saw
should be re-established and the cordless
sabre saw is ready for use.
˜ Reset to factory original
setting
{Reset}
Select to restore the firmware to
o
original factory setting.
˜ Privacy policy
You can find the complete data protection
guideline under the tab in the field
protection guideline}.
˜ Disconnecting the product and
deleting data from the app
1. In the tab, select the product that you
want to remove and whose data you want to
delete.
2. Select the icon in the top right.
{Remove device}.
3. Select
4. To delete the data, select
delete data}. If you just want to disconnect
the device without deleting the data, select
{Disconnect}.
˜ Problems with the app – FAQ
1. Select the battery pack you have questions
about from the device list.
2. Select the icon in the top right.
{Other}
3. Under select the option
{FAQ}
(= frequently asked questions).
22 GB
"PSSAP 20 Li C4
version}
and update the
{Data
{Disconnect and
˜ Cleaning and care
m WARNING!
Always switch the product off, remove
the battery pack
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
safe use and prolong the life of the product.
Clean the product with a dry cloth. Use a soft
brush for areas that are hard to reach.
In particular clean the air vents after every
use with a cloth and soft brush.
The vents must always be clear.
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces.
˜ Maintenance
Before and after each use, check the product
and accessories (e.g. saw blades) for wear
and damage. If required, exchange them
for new ones as described in this instruction
manual. Observe the technical requirements
(see "Technical data").
Check covers and safety devices for damages
and correct installation. Replace as necessary.
Replace a blunt or bent saw blade or one
which has been damaged in some other way.
and let the
8 ] [