Parkside Performance PSSAP 20 Li C4 Originalbetriebsanleitung Seite 22

{Remove device}
See chapter "Disconnecting the product and
o
deleting data from the app".
˜ Cordless sabre saw
{Device info}
If you select
(2201)" under {Battery}, the overview page
of the cordless sabre saw is displayed with the
following details:
–
ID of the power tool
–
name of the power tool
–
discharge current (in ampere)
–
rotation speed of the motor (rpm)
{Tool work mode}
Select work modes:
o
– {Performance}
discharge current for heavy duty tasks
– {ECO}
{Light delay off setting}
The LED work light
o
some time after switch-off. This time can be set
from 1 to 99 seconds.
{Usage statistics}
Usage statistics of the cordless sabre saw are
o
displayed as:
–
Total runtime
–
Number of over temperature protection
–
Number of stalls
–
Number of over current protection
{Firmware version}
Checking the firmware version of the power
o
tool:
–
If a red dot is displayed next to the version
it indicates that a new firmware version is
available. When you select
version}, you can select
firmware}. The update status bar shows
the transmission of new firmware to the
battery pack.
{Update success}
o
of the new firmware to the battery pack.
The battery pack disconnects from the Lidl
Home app. The firmware update will start.
"PSSAP 20 Li C4
‒ allows higher
continues to be on for
[ ]
{Firmware
{Update of
means successful transfer
m IMPORTANT!
During the firmware update, the connection status
LED flashes 5x per second. Do not disconnect
[ ]
the smart battery pack from the cordless sabre
saw during the update as the cordless sabre saw
becomes unusable if the update fails. During
the update, the cordless sabre saw becomes
unresponsive to input, e.g. triggering the on/
off switch. The update process takes around
5 minutes. If the firmware update is successful,
the connection status LED flashes 1x per second
for 5 seconds. The cordless sabre saw becomes
responsive to input again. You can connect the
battery pack to the Lidl Home app following the
chapter "Connecting the product to the Lidl Home
app".
˜ Reconnecting the cordless
sabre saw
m IMPORTANT!
If the connection status LED
alternatively between 1x and 5x per second, it
means the connection was disrupted. One of the
reasons is disconnecting the battery pack from the
cordless sabre saw during firmware update. The
cordless sabre saw will not be usable until you
re-establish the connection.
Proceed as follows to re-establish the connection
with the cordless sabre saw:
1. Attach the battery pack to the cordless sabre
saw.
2. Release the switch lock
3. Press the on/off switch/speed control
connection status LED
1x or 5x per second.
4. Enable Bluetooth on your mobile product.
5. Press and hold the
level) on the smart battery pack for
[ ]
3 seconds to ensure that Bluetooth is
activated on the battery pack.
flashes
[ ]
.
5 ] [
. The
6 ] [
flashes alternatively
[ ]
button (charging
GB 21