Parkside Performance PSSAP 20 Li C4 Originalbetriebsanleitung Seite 18

m CAUTION! RISK OF INJURY!
Do not use any blunt, bent or damaged
u
saw blade.
Always install a suitable saw blade for the
u
job.
Inserting the saw blade
(Fig. F)
Turn the chuck ring
direction.
Insert the saw blade into the saw blade
holder .
3 ] [
Release the chuck ring
its original position.
Before use: Pull on the saw blade and check
if it is inserted safely and tightly.
Removing the saw blade
(Fig. G)
Turn the chuck ring
direction.
Pull the saw blade out of the saw blade
holder .
3 ] [
Release the chuck ring
its original position.
NOTE
For certain work, the saw blade can also
u
be inserted after turning through 180°.
˜ Switching on and off
m CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product.
m CAUTION! RISK OF INJURY!
Before switching on the product: Ensure
u
the saw blade is not in contact with the
workpiece.
Ensure your stance is stable. Always hold
u
the product's front
firmly with both hands while working
(Fig. H).
Keep your hands away from the saw blade
u
when the product is in operation.
in a counter-clockwise
[ 2 ]
and let it return to
2 ] [
in a counter-clockwise
2 ] [
and let it return to
2 ] [
and rear handle
[ 9 ] 7 ] [
NOTE
The on/off switch
u
(Fig. I)
Switching on: Release the switch lock
by pushing it in on the left or right side.
Press and hold the on/off switch
Regulate the speed as required (see "Speed
control").
Switching off: Release the on/off
switch .
[ 6 ]
When releasing the on/off switch, the switch
lock moves back into its original position.
[ 5 ]
˜ Speed control
By using the on/off switch
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
to illuminate the immediate working area to
improve visibility in poorly lit areas.
The LED work light
as soon as the product is switched on.
NOTE
The LED work light
u
additional approx. 10 seconds after
switching off the product.
˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every saw
blade replacement. Switch the product off
immediately if the saw blade is not running
smoothly, if considerable vibration occurs
or if you hear abnormal noises.
cannot be locked.
[ 6 ]
[ 5 ]
.
[ 6 ]
, you can
6 ] [
Speed
Lower
Higher
lights up automatically
[ ]
stays on for an
[ ]
GB
[ ]
17