End Of Season - Ransomes Parkway 2250 Plus Bedienungsanleitung Und Wartungsanleitung

8 LUBRICATION AND MAINTENANCE
8.10 END OF SEASON or when required
Change Hydraulic filter.
1. Lower the centre cutting unit to improve
access.
2. Wipe filter bowl (A) and housing to remove
any dirt present.
3. Place a suitable drip tray on top of the centre
cutting unit.
4. Unscrew bowl and remove oil filter element
and disposes of safely.
5. Replace with new element.
6. Coat the top outside lip of the filter bowl with
a thin film of oil and refit filter bowl and
torque to 54Nm, as indicated on decal.
7. Start engine and idle for 15 seconds.
8. Stop engine, check filter bowl for leaks and
check reservoir
NOTE: It is important that absolute cleanliness
is observed when changing the filter.
Change Coolant.
1. Completely drain the cooling water from the
radiator drain plug (B) and flush the cooling
system with flushing detergent.
2. Check for leaks or loose connections at the
radiator, cylinder head gasket, drain cock etc.
3. Mix antifreeze coolant and water at the
specified ratio before pouring into the engine.
Note: When topping up the cooling system fill with a
50/50 solution.
Check Rear Wheel Bearings. (2WD Only)
1. Jack up, and securely chock the rear of the
machine using points indicatored in
2. Check for free-play in bearings,
3. If free-play is found remove dust cover and
split pin and tighten castlated nut till all free-play is
eliminated.
Transmission Foot Pedal & Cable
Inspect the cable for damage and freedom of
movement. Fully cycle the cable to check that the
inner element is in good condition. Inspect the outer
sheath for damage and alignment. Correct or
replace as appropriate
en-42
section 5.2
RANSOMES PARKWAY 2250 PLUS
SAFETY AND OPERATORS MANUAL