Description Of Appliance - clage DCX 13 Gebrauchsanleitung

CLAGE

2. Description of appliance

The instantaneous water heater DCX / DCX 13 is a electronic-con trolled, pressure-
resistant water heater for a decentralised water supply to one or more taps.
As soon as you open the hot water tap,the instantaneous water heater switches
EN
on auto matically. When the tap is closed, the appliance automatically switches
off.
Its electronic control regulates the power consumption automatically depending on the
feed temperature and the flow rate, thus reaching the set outlet temperature up to the
appliance's power limit.
It is also possible to define the outlet temperature by mixing the hot water (55 °C) from
the instantaneous water heater with cold water by the tap. However, energy and water
will be saved when selecting the relative temperature to be used on the display of the
instantaneous water heater, without mixing cold water from the tap.
In case of a low feed temperature and a high flow rate at the same time, it could hap-
pen that the pre-set outlet temperature is not reached which is due to the fact that the
appliance exceeded its capacity. The outlet temperature can be raised by reducing the
water flow at the tap.
It is possible to use the instantaneous water heater in combination with an external
load shedding relay for electronically controlled instantaneous water heaters (refer to
installing instructions).
7