Operation Instruction; Description Of The Appliance; Environment And Recycling - clage DBX 18 Next Gebrauchs- Und Montageanleitung

Operation instruction

Note: Carefully read the enclosed safety instructions through in full before the appliance
is installed, put into service and used and follow them in the further steps and during use!

1. Description of the appliance

2. Environment and recycling

Your product was manufactured from high-quality, reusable materials and components. Please respect in case of discarding that
electrical devices should be disposed of separately from household waste at the end of their service life. Therefore, please take this
device to a municipal collection point that return used electronic devices to the recycling system. Disposing it correctly will support
environmental protection and will prevent any potential negative effects on human beings and the environment that could arise
from inappropriate handling of these devices at the end of their service life. Please contact your local authority for further details of
your nearest designated collection point or recycling site.
Business customers: If you wish to discard equipment, please contact your dealer or supplier for further information.
The E-basic instant water heater DBX Next is a electronically controlled pressure-
resistant instantaneous water heater for an efficient water supply to one or more tap
outlets.
As soon as you open the hot water tap, the instantaneous water heater switches on
auto ma ti cally. When the tap is closed, the appliance automatically switches off.
Its electronic control regulates the power consumption depending on the selected
outlet temperature, the respective inlet temperature and the flow rate, thus reaching
the set temperature exactly to the degree and keeping it constant in case of water
pressure fluctuations.
The factory set outlet temperature is 50 °C. This factory setting can be adjusted in the
appliance to be in a range of approx 30 °C and 60 °C by a specialist only.
Note: The hot water temperature may not exceed 55 °C if the instant water heater is
connected to a shower.
In case of a low feed temperature and a high flow rate at the same time, it could hap-
pen that the preset outlet temperature is not reached which is due to the fact that the
appliance exceeded its capacity. The outlet temperature can be raised by reducing the
water flow at the tap.
It is possible to use the instantaneous water heater in combination with an external
load shedding relay for electronically controlled instantaneous water heaters (refer to
installing instructions).
17
CLAGE
EN