Description Of Appliance; Technical Specifications - clage MBH 3 Gebrauchs- Und Montageanleitung

Description of appliance

1. Description of appliance
This instantaneous water heater is intended to provide the economical heating of water suf-
ficient for a single outlet, i.e. handwash basin, and is installed together with a sanitary water
fitting.
When the hot water tap is opened, the instantaneous water heater switches itself on auto-
matically and heats the water as it passes through the appliance. It is only then that the appli-
ance uses electricity. The temperature increase depends on the flow rate.

1.1 Technical specifications

Type
Energy efficiency class
Capacity
Rated Pressure
Connecting type
Heating system
Min. water resistance at 15 °C
Max. water inlet temperature
Rated voltage
Rated power
Rated current
Required min. cable cross-section
Hot water output at ∆t = 25 K
Switching on at
Switching off at
Approx. weight when filled with water
Protection class
Marking / Approvals
*) The declaration complies with the EU regulation No 812/2013.
1) The specific resistance can be asked for at your water distribution company.
2) Temperature increase from e. g. 15 °C to 40 °C.
MBH 3
Litre
MPa (bar)
Ωcm
1)
°C
kW
A 15.2
mm 2
l/min
2)
l/min
l/min
kg
MBH 4
A
1 (10)
pressure-resistant / pressureless
Bare wire heating system IES ®
1100
1~ / N / PE 230 V AC
3.5 4.4
19.1
1.5 2.5
2.0 2.5
1.3 1.8
1.0 1.4
IP 25
see rating plate
19
MBH 6 MBH 7
*)
0.2
20
2~ / PE 400 V AC
5.7 6.5
24.8 16.3
4.0 1.5
3.3 3.7
2.2 2.4
1.7 2.0
1.5
CLAGE
EN