Configuration Of Robot Interface; Dip-Switch Function; Configuration Of The Process Data Width; Set Node Address With Dip Switch(Example) - Fronius Ri Fb Inside/I Bedienungsanleitung

Configuration of robot interface

Dip-switch func-
tion
(3)
Configuration of
the process data
width
OFF
OFF
The process data width defines the scope of the transferred data volume.
The kind of data volume that can be transferred depends on
-
-
-
Set node ad-
dress with dip
switch
(example)
The node address is set with positions 1 to 6 of the dip switch.
The configuration is carried out in binary format. This results in a configuration
range of 1 to 63 in decimal format.
28
(2)
Dip switch
8 7 6 5
OFF - -
ON - -
ON OFF - -
ON ON - -
the robot controls
the number of welding machines
the type of welding machines
- "Intelligent Revolution"
- "Digital Revolution" (Retro Fit)
Dip Switch
8 7 6 5
- - OFF OFF
- - OFF OFF
- - OFF OFF
- - ON ON
The dip-switch (1) on the robot inter-
face RI FB Inside/i is used to configure
- the process data width
- the node address/IP address
(1)
At the factory all positions of the dip
switch are set to OFF (3).
This corresponds to the binary value 0.
The position (2) corresponds to the bi-
nary value 1.
4 3 2 1
- - - -
- - - -
- - - -
Scope dependent on bus module
- - - -
4 3 2
OFF OFF OFF
OFF OFF ON
OFF OFF ON
ON ON ON
Configuration
Standard image
320 Bit
Economy image
128 Bit
Retro Fit
Not used
1 Node address
ON 1
OFF 2
ON 3
OFF 62