Display Indications And Symbols - VOLTCRAFT LCR-300 Bedienungsanleitung

5.1. DISPLAY INDICATIONS AND SYMBOLS

A Bar chart shows utilisation of the measured range in %
B Function and operating displays
Ext-Power
Sorting
CAL
Tol
120 100 KHz
Battery symbol shows the battery status in battery operation
C Main parameter for measuring operation
s = serial for serial circuits in AC operation (Ls, Cs, Rs)
p = parallel for parallel circuits in AC operation (Lp, Cp, Rp)
DCR = direct current resistance (DC)
D Symbol for active automatic deactivation
E Measuring functions
HOLD
AUTO
AUTO LCR
RANGE:
REL
F Main display with measuring units
G Sub-display with measuring units
H Subfunctions for the subdisplay
ESR
RP
DQθ
36
shows mains unit operation
shows sorting mode
shows calibration mode
shows the pre-set tolerance range for sorting
shows the measuring frequency
Data hold is active, the displayed measured value is stored
Automatic measuring operation with pre-selection of the measuring parameter (L, C, R)
Smart automatic measuring operation without pre-selection of the measuring parameter
Range display in sorting mode
Reference value display mode
Equivalent serial resistor
Equivalent parallel resistor
D = dissipation factor , Q = quality, θ = phase angle