Scope Of Delivery; Intended Use - VOLTCRAFT LCR-300 Bedienungsanleitung

3. SCOPE Of DELIVERY

LCR measuring device
6 micro batteries (type AAA)
2 Kelvin measuring lines, red and black
calibration plug ("SHORT")
Bag
Operating instructions

4. INTENDED uSE

- Measuring and displaying the electrical values of coils (L), capacitators (C) and resistors (R) and their
combinations (parallel/serial)
- Measuring inductivities of up to 2000 H
- Capacity measurement up to 20 mF
- Measuring resistors (AC-R/DC-R) of up to 200 MOhm
- Displaying the quality factor "Q"
- Displaying the electrical loss factor "D"
- Displaying the phase angle "θ" (0.00° to ±180.0°)
The measurement functions and measuring ranges are selected using the pushbuttons. Automatic
measuring range selection is active in all measuring areas.
Components must only be connected to the measuring device when powered down and discharged.
No voltages must be applied to the measuring device.
The measuring device must not be operated when it is open, i.e. with an open battery compartment or
when the battery compartment cover is missing. Measurement under unfavourable ambient conditions
is not permitted.
Unfavourable ambient conditions are:
- dust and flammable gases, vapours or solvents,
- thunderstorms or similar conditions such as strong electrostatic fields, etc.
For safety reasons, only use measuring lines or accessories which are adjusted to the specifications of
the multimeter when measuring.
Any use other than that described above damages the product. Moreover, this is linked to dangers
such as short circuit, fire, electric shock, etc. No part of the product must be modified or converted!
Read the operating instructions carefully and keep them for later reference.
Always observe the safety information!
34