Parkside PGSA 4 A2 Originalbetriebsanleitung Seite 25

Sound pressure level
) ...................63.0 dB(A), K
(L
pA
Sound power level (L
guaranteed ........................... 77 dB(A)
measured .....74.1 dB(A); K
Vibration (a )
h
at handle ......... 2.41 m/s
Battery (Li-Ion)
Nominal voltage .............. 4 V
Power supply unit ..........................
WJG-Y130502200WU1/
WJB-Y130502200WU1
Grizzly Tools GmbH & Co. KG
Stockstädter Straße 20
DE-63762 Großostheim
HRA: 5468, Amtsgericht Aschaffenburg
Input voltage ............................100-240 V~;
Input AC frequency .......................50-60 Hz
Power input ................................. 25 W
Rated output ................................ 5 V
Output current ......................... 2200 mA
Output power ............................ 11.0 W
Average active effi ciency ............. 82.9 %
Effi ciency at low load (10%) ......... 83.1 %
Power consumption at zero load .. 0.08 W
Protection class ...............................
Protection category...........................IPX0
The noise and vibration levels have been
calculated according to the norms stated in
the conformity statement.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value de-
= 3 dB
pA
)
WA
= 2.47 dB
WA
2
, K=1.5 m/s
; 2 Ah
pending on the manner in which the power
tool is used.
Try to keep the exposure to vibrations as low
as possible. Examples of measures to reduce
vibration exposure are the wearing of gloves
when using the tool and limiting the working
2
hours. For this purpose all parts of the oper-
ating cycle have to be considered (for exam-
ple, times when the electric tool is switched
off and times when it is switched on but run-
ning without any load).
Safety Instructions
This unit can cause serious in-
jury if not used correctly. Be-
fore using the unit, carefully
read through the instruction
manual and familiarise your-
self with all of its controls.
Symbols
Symbols in the manual
Warning symbols with in-
formation on damage and
injury prevention.
II
There is a risk of injury from
electric shock.
Instruction symbols with information
on preventing damage.
Help symbols with information on
improving tool handling.
Wear anti-slip safety shoes.
Wear cut-resistant gloves.
Wear eye and ear protection.
GB IE
25