Check Clutch And Fan; Media Lines - Elmo Rietschle V Serie Originalbetriebsanleitung

MAINTENANCE, SERVICING AND DISMANTLING
8.4.6

Check clutch and fan

Fig. 14 Clutch and fan
The spider of the clutch is subject to wear and must be checked regularly.
In this area, there are also other maintenance activities that need to be taken into account at the same
intervals.
1. Ensure that all requirements for maintenance operation have been met
2. Attach the hoist to the transport lugs (1) of the motor
3. Loosen the 4 nuts (2) on the intermediate flange and pull it off axially together with the motor
4. Check both coupling halves (3+5) and the spider (4) for damage (e.g. cracks in the spider) and wear,
replace if necessary
5. Visually inspect the pump fan (6). In the event of visible damage, replacement is urgently required.
Support is available from our Elmo Rietschle service centre
6. Installation is carried out in reverse order. Ensure that the two coupling halves are correctly centred
8.5

Media Lines

WARNING
Lines, hoses, pipes, valves and connections must be checked for damage (leaks) at regular intervals.
The following instructions must be observed when carrying out maintenance and repair work on media lines:
• Before starting work on the media lines, the system must be depressurised and secured against being
switched on again. Residual energy must be dissipated or discharged. Residual liquids in media lines
must be drained off.
34
|
www.elmorietschle.com © Gardner Denver Schopfheim GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
Risk of injury due to stored residual energies
Tel. 071 918 60 60, Mail: v-g@prematic.ch