SOMFY RS100 SOLAR io Anleitung Seite 4

EN
2.1.Assembly
2.1.1.Preparing the drive
CAUTION
RS100 SOLAR io : interior diameter of the tube has to be Ø47 mm or greater.
1] Fit the accessories required to integrate the drive into the tube:
ð Either only wheel (a) on the drive
ð or crown (b) and wheel (c) on the drive.
2] Measure the length (L) between the inner edge of the drive head and the rim
of the wheel.
2.1.2.Preparing the tube
1] Cut the winding tube to the required length, depending on the motorised
product.
2] Deburr the winding tube and remove the swarf.
3] For winding tubes which are smooth inside, cut a notch with the following
measurements:
g RS100 SOLAR io : l = 4 mm, L = 28 mm.
2.1.3.Assembling the drive-tube
PRECAUTION
The screws or pop rivets must only be fastened on the wheel and not on the
drive.
1] Slide the drive into the winding tube. For winding tubes that are smooth
inside, position the cut notch on the protruding part of the ring.
2] The drive wheel must be locked in a straight line inside the winding tube:
g either by securing the winding tube to the wheel using 4 x Ø5 mm Parker
screws or 4 x Ø4.8 mm steel pop rivets located between 5 mm and 15 mm
form the outside edge of the wheel, irrespective of the type of winding
tube.
g or by using a wheel lock, for non-smooth tubes.
4
1]
Ø
a
2]
1)
3)
1]
2]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
RS100 SOLAR io
Ø Ø Ø
c
b
L
2)
l
L
15 mm
5 mm
L