Removing The Side Rack-Holder Frames - NEFF F 3460 Serie Gebrauchsanleitung

Removing the side
rack-holder frames
98
To re-fit the door, carry out the instructions given
above in the reverse order. When the hinges B are
back in their seats, open the door all the way and re-
fit the safety catches of the hinges, lowering the pins
A (one for each hinge).
CAUTION: Make sure that the hinge safety pins are
always correctly refitted.
The rack retaining frames can be removed for clean-
ing separately and to make it easier to clean the oven
walls. The frames are hooked to the oven wall in the
three points indicated by the arrows in the figure
(detail 1).
• Press downward with your fingers as shown in
detail 2 of the figure to release the frame from the
upper pin.
• Lift the frame upwards and take it out.
To re-fit proceed in the reverse order. Set the lower
part of the frame on the pins and press the upper
part against the oven wall until it hooks onto the pin.