Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
70
The threaded 1/2" gas connection pipe is located at
the rear on the right hand side of the appliance. A
pressure reducer complying with current stan-
dards must be provided for butane or propane
gas. The gaskets shall also comply with current stan-
dards.
Once the gas has been connected, check the seal of
the unions with a soap and water solution.
Using flexible pipes:
• do not allow the pipes to be constricted or
crushed;
• the pipes must not be subjected to traction or twist-
ing forces;
• do not allow the pipes to come into contact with
cutting or sharp edges, etc...
• do not allow the pipes to come into contact with
parts that can reach temperatures of more than
70 K above room temperature; make sure that
the entire length of the pipes is available for inspec-
tion
Particular care must be taken to ensure leakproof
connection.
The unit must be coated in heat-resistant material
(minimum 90°C). If the appliance is installed close to
other units, the minimum space suggested in the fol-
lowing diagram must be left.
Werbung
Kapitel
Inhaltsverzeichnis
