Inhaltsverzeichnis
Werbung
Guidance and manufacturer's declaration-electromagnetic
The I-TECH UT2 device is intended for use in the electromagnetic environment specified below. The
customer or the user of the I-TECH UT2 should assure that it is used in such an environment.
Immunity
IEC 60601
test
test level
Electrostatic
±6 kV contact
discharge
(ESD) lEC 61000-
± 8kV air
4-2
Immunity
Compliance
Electromagnetic
level
environment - guidance
Floors should be wood, concrete
± 6kV contact
or ceramic tile. If floors are
covered with synthetic material,
the relative humidity should
be at least 30 %.
± 8kV air
Guidance and- manufacturer's declaration. Electromagnetic immunity
FOR EM DEVICES THAT ARE NOT INTENDED FOR LIFE SUPPORT
The I-TECH UT2 device is intended for use in. the electromagnetic environment specified below. The
customer or the user of the I-TECH UT2 should assure that it is used in such an environment.
Immunity
test
Portable and mobile RF communications equipment should be used no closer to any
part of the I-TECH UT2 device, including cables, than the recommended separation distance calculated
from the equation applicable to the frequency of the transmitter.
3V effective
Conducted RF lEC
from
61000-4-6
80MHz
3V/m
Radiated RF lEC 61000-
from
4-3
2,5GHz
Transmitter manufacturer and d Is the recommended separation distance in
meters (m). Field strengths from fixed RF transmitters, as determined by an electromagnetic site
a survey, should be less than the compliance level b in each frequency range. Interference may occur
In the vicinity of equipment marked with the following.:
NOTE I At 80 MHz ends 800 MHz. the higher frequency range applies.
I.A.C.E.R. Srl
IEC 60601
Compliance
test level
level
Portable
150kHz
to
3V (V
)
communications
1
should be used no closer to any
part of the I-TECH UT2 device,
including
recommended
distance calculated from the
equation
frequency of the transmitter.
Recommended
distance.
80MHz
to
3V/m (E
)
d = 1,2 P from 150kHz to 80MHz
1
d = 1,2 P from 80 MHz to 800
MHz
d = 2,3 P from 800 MHz to 2,5
GHz
where P is the maximum output
power rating of the transmitter In
watts (W) according to the.
Electromagnetic
environment – guidance
Electromagnetic
environment - guidance
and
mobile
RF
equipment
cables,
than
the
separation
applicable
to
the
separation
19
Werbung
Inhaltsverzeichnis
